ioLogik E1200 Series
Using the Web Console
3-12
The ioLogik E1200 allows you to manually adjust the current temperature reading. In each channel
configuration section, select the channel, apply the offset value, and click the “Submit” button to perform the
task.
System Management
IP Accessibility
You can control network access to the ioLogik E1200 from the IP Accessibility page by only allowing access from
specific IP addresses. When the accessible IP list is enabled, a host’s IP address must be listed in order to gain
access to the ioLogik E1200.
Specify a range of addresses by using a combination of an IP address and netmask, as follows:
To allow access to a specific IP address
Enter the IP address in the corresponding field; enter
255.255.255.255
for the netmask.
To allow access to hosts on a specific subnet
For both the IP address and netmask, use
0
for the last digit (e.g.,
192.168.1.0
and
255.255.255.0
).
To allow unrestricted access
Deselect the
Enable the accessible IP list
option.
Refer to the following table for additional configuration examples.
Allowed Hosts
IP address/Netmask
Any host
Disable
192.168.1.120
192.168.1.120 / 255.255.255.255
192.168.1.1 to 192.168.1.254
192.168.1.0 / 255.255.255.0
