ioLogik E1200 Series
Initial Setup
2-2
Hardware Installation
Connecting the Power
Connect the 12 to 36 VDC power line to the ioLogik E1200’s terminal block on the top panel. If power is properly
supplied, the Power LED will glow a solid amber color.
ATTENTION
Disconnect the power cord before installing or wiring your ioLogik E1200.
Do not exceed the maximum current for the wiring
Determine the maximum possible current for each power wire and common wire. Observe all electrical codes
dictating the maximum current allowable for each wire size. If the current exceeds the maximum rating, the
wiring could overheat, causing serious damage to your equipment. For safety reasons, the wires attached to
the power should be at least 2 mm in diameter.
Grounding the ioLogik E1200
The ioLogik E1200 is equipped with a grounding point on the terminal block located on the top panel.
Connect the ground pin (
) if earth ground is available.
Connecting to the Network
The ioLogik E1200 has two built-in Ethernet switch ports for connecting a standard direct or cross-over
Ethernet cable from RJ45 port to either the host PC or another ioLogik E1200 device. For initial setup of the
ioLogik E1200, it is recommended that the ioLogik E1200 be configured using a direct connection to a host
computer rather than remotely over the network.
Configure the host PC’s IP address to 192.168.127.xxx (where xxx ranges from 001 to 253). When using
Windows, you will need to do the configuration from the Control Panel.
ioLogik E1200 Default IP Address
Default Netmask
Default Gateway
192.168.127.254
255.255.255.0
None
Use the web console or ioSearch configuration utility to connect to the ioLogik E1200. Once the ioLogik E1200
has been detected, modify the settings as needed for your network environment, and then restart the server.
Refer to Chapters 3 and 4 or further details.
