30mm Minimum
Clearence
PRE-INSTALLATION RECOMMENDATIONS
INSTALLATION INSTRUCTIONS
1.
Garage door must be able to be lifted and closed easily by hand and without much effort. A well
balanced & sprung door is critical for proper installation.
2.
The garage door opener can’t compensate for a badly installed garage door and should not be
used as a solution for a “hard to open” door.
3.
If the unit is being installed on an existing door, make sure any existing locking devices are
removed or warranty will be void.
4.
An approved outlet must be installed near where the opener is begin installed.
5.
There should be a minimum gap of 30mm between the bottom of the chain drive rail and the top
of the garage door at its closest point. (refer to Fig 1.)
Important note: As for additional safety rules, we strongly recommends the fitting of Photo Electric
safety beams on all installations.
Wall Bracket -
Close the garage door and measure
the garage door width at the top and mark the
centre. Locate and mount the wall bracket
2cm-15cm above the door on the inside wall.
(Depend on the actual installation space).
Door Bracket –
Fix the door bracket to a structural
part of the door as close to the top edge as possible
Figure 1
Mount Wall Bracket and Door Bracket (Fig2)
Figure 2
-4
D
-
Summary of Contents for Force+ 1000N
Page 31: ......
