E. MAINTENANCE ALARM - OPERATION CYCLES COUNT
SETTING
a) Press and hold
SET
Button until “
1
” appears on the display,
next press the
UP
button until “
E
” appears on the display to
enter this function setting then release the button.
b) Press the
SET
button again. The unit is now in the
maintenance alarm adjustment mode. And then you will see
a figure “
0
” with flash dot appears on the display.
c) Press
UP
/
DOWN
button, you can select the operation cycles
you need the opener to make you notice. You can choose
from “
1
-
5
” set.
Figure “
1
” means, after garage door operated to 1000 times,
the L.E.D light will flash 10 times quickly after the door stop
working every time. In order to make you notice that your
garage door need to do maintenance . And at the same time,
you will see a figure “t” appears on the display.
Figure “
2
” means the maintenance alarm count cycle is set
on 2000 times.
Figure “
3
” means the maintenance alarm count cycle is set
on 3000 times.
Figure “
4
” means the maintenance alarm count cycle is set
on 4000 times.
Figure “
5
” means the maintenance alarm count cycle is set
on 5000 times.
c) Press
SET
button to confirm the set and it will be back to
standby status automatically and display “ll”.
NOTE:
1. The operation cycles count is set on “
0
” as standard in
factory.
2. “b” appears on display and led light flashes 10 times
quickly means the door lost balance, strong recommend the
maintenance for garage doors.
3. “Check” the status, or “ Re-learn” the travel limit after
maintenance alarm cautions.
-19
D
-
Summary of Contents for Force+ 1000N
Page 31: ......