D. PHOTO CELL ON/OFF SETTING
NOTE
: Make sure the photo cell has been correctly installed
and used Normally Closed contacts to the accessory
terminals of the opener.
Also note that the photo beam function must be disabled
if NO photo beams are fitted, otherwise the door cannot
be closed, and the LED display will show the letter“ r ”as an
indication.
a) Press and hold
SET
Button until “
1
” appears on the display,
next press the
UP
button until “d” appears on the display to
enter this function setting then release the button.
b) Press the
SET
button again. The unit is now in the photo
cell ON/OFF adjustment mode. And then you will see a
figure “
0
” with flash dot appears on the display.
c) Press
UP
/
DOWN
button once to set the photo cell ON/OFF
switch. You can choose “
0
” or “
1
”set.
Figure “
0
” means, the photo cell function is closed.
Figure “
1
” means, the photo cell function is open.
d) Press
SET
button to confirm the set and it will be back to
standby status automatically and display “ll”.
NOTE:
The photo cell is set on “
0
” as standard in factory.
-18
D
-
Summary of Contents for Force+ 1000N
Page 31: ......
