Motrona touchMATRIX AX350, Operating Manual

Page: 22 / 54

Ax350_04a_oi_e.doc / May-18 Seite 22 / 54
5.4 IN 1 Totalization
The totalization function is defined in this menu. This menu will only be showed, if the totalization is
active in Menu IN 1 PROPERTIES.
The totalizator depends on the operation mode. See in the following list.
Operation mode
Totalisation
INPUT 1 TOTAL INPUT 2 TOTAL LINKAGE TOTAL
SINGLE aktiv

0
DUAL aktiv aktiv
IN1 + IN 2 aktiv aktiv
IN1 – IN 2 aktiv aktiv
IN1 x IN 2 aktiv aktiv
IN1 / IN 2 aktiv aktiv
TIME BASE
This parameter defines the time base of the totalization.
It defines the time interval between the recordings of data.
0 SECONDS The current value is added to INPUT 1 TOTAL every second
1 MINUTES
The current value is added to INPUT 1 TOTAL every minute
2 HOURS
The current value is added to INPUT 1 TOTAL every hour
3 COMMAND
The current value is added to INPUT 1 TOTAL, when using the command (ADD TO
TOTAL 1) for the operation function at the control input (see Command Menu)
DIVIDER
This parameter defines the devisor for the totalization.
0 1 No division
1 10 The result of the totalization is divided by 10
2 100 The result of the totalization is divided by 100
3 1000 The result of the totalization is divided by 1000
DECIMAL POINT
This value defines the position of the decimal point.
0 NO
No decimal point
1 0000000.0
Decimal point at the specified position
2 000000.00
Decimal point at the specified position
3 00000.000
Decimal point at the specified position
4 0000.0000
Decimal point at the specified position
5 000.00000
Decimal point at the specified position
6 00.000000
Decimal point at the specified position
7 0.0000000
Decimal point at the specified position
SCALE UNITS
This parameter defines the required engineering unit. This parameter does not affect the calculation of the display
value. The number of decimal places must be defined with the parameter DECIMAL POINT. A list of available units
can be found in Chapter 6.2 Appendix: Display of scale units.