Motortech EasyNOx, Operating Manual

Page: 10 / 142

10 Rev. 06/2021
2.1 General Safety Instructions
The following safety instructions must be followed in the area in which the device is operated:
High voltage! Danger to life!
While the engine is running, there is danger to life through high voltage par-
ticularly in the area of the ignition system. The following parts should there-
fore not be touched or removed unless explicitly stated otherwise:
– Ignition coils and caps
– Wires of the high voltage circuit
– In- and output wiring of the ignition controller
– Pickups and their wiring
Danger to persons with pacemakers!
Electromagnetic impulses in the wiring of the ignition system may exceed
the permissible limits of pacemakers. Persons with pacemakers must there-
fore not be present in the vicinity of the ignition system being operated.
Mark the operating location of the ignition system with the corresponding
standardized warning symbol.
MOTORTECH equipment is manufactured as state of the art and therefore safe and reliable to
operate. Nevertheless the equipment can cause risks or damage can occur, if the following in-
structions are not complied with:
– The gas engine must only be operated by trained and authorized personnel.
– Observe all safety instructions of the system and all safety instructions of the system opera-
tor.
– Operate the equipment only within the parameters specified in the technical data.
– Use the equipment correctly and for its intended use only.
– Never apply force.
– For all work such as installation, conversion, adaptation, maintenance, and repair, all equip-
ment must be disconnected from the mains and secured against unintentional reactivation.
– Perform only such maintenance and repair work as is described in this operating manual,
and follow the instructions given while working.
– Only use spare parts supplied by MOTORTECH for the maintenance of the device.
– Further work must only be performed by personnel authorized by MOTORTECH. Non-compli-
ance with the instructions will void any warranties for the proper function of the equipment
as well as the responsibility for the validity of the certifications.
– Safety devices must not be dismounted or disabled.
2 Safety Instructions