Motorola V8162, Service Manual

Page: 53 / 93

10/23/00
slowly push the tool in the direction of the light-
guide. Any deviation from this movement and
position can result in damage to the flex
connector. Once pressure is felt against the tool,
ensure that a guard is placed to stop the guide
from getting lost, then push firmly against the
guide keeping the body of the tool flush with the
housing till the guide comes out. (If the guide
does not come out then extract it with snips).
Fully retract pin before the tool is lifted from
the housing. Ensure no damage has occurred
to battery retention clip.
Place the unit on its rear.
Whilst pushing on
the antenna mount, insert the flat end of the
plastic bezel tool between the housing and each
of the 4 catches to release the rear housing. When
all 4 catches are released, remove the rear
housing from the antenna end of the transceiver
at an angle.
Step 4. Transceiver disassembly
Using the flat end of the plastic bezel tool, lift the
black Zif connector gate.
(If this gate breaks the whole connector must be
replaced).
Make sure the ends of all the flex
traces enter or leave the ZIF simultaneously.
Otherwise it is possible to create new, inter-
mittent shorts between traces; see the