Motorola V8162, Service Manual

Page: 26 / 93

V8160
This will cause the phone to enter the Test
Table 8:
Keypad
Entry
Command
Description
Status Display Result
# Suspend
Terminate normal mode and enter Test Command Mode.
This command is valid only when in normal mode. The #
key must be held for 2 seconds to suspend with handset.
Performs initialization as in the INIT test command.
01# Restart Equivalent to turning power off, then on again.
02# Radio Start
Request AAAZBBBC-
DEFGHI
Display the current radio status:
Handset Display Format:
AAA = Current channel
(1000-1023 represented as A00-A23)
Z = Blank - AMPS
Analog Mode:
BBB = RSSI reading (averaged) for this channel.
C = Digital Color Code (data channel) 0-3 DCC, 4
invalid
= SAT Frequency (voice channel)
0=5970 Hz; 1=6000 Hz; 2=6030 Hz;
3=No SAT Lock
D = Carrier (0=OFF, 1=ON)
E = Word sync status (data channel) and Signalling
tone (voice channel)
(0=OFF, 1=sync acquired/ON)
F = RF Power Level (Steps 0-7)
G = Reception Mode
(0=voice channel, 1=data channel)
H = Receive Audio (0=enabled, 1=muted)
I = Transmit Audio (0=enabled, 1=muted)
CDMA Mode: (Not currently supported)
Bit fields undefined
03# (not used)
04# Initialize Trans-
ceiver
Initialize the current radio as follows:
1. Carrier = OFF
2. RF power attenuation set to level 2
3. Signaling Tone = OFF
4. SAT transponding = OFF
5. Audio Path = TO INTERNAL SPEAKER
6. DTMF & Audio Tones = OFF
7. Receive Audio & Transmit Audio = MUTED
8. AMPS Mode
If the radio is a CDMA only model (not dual mode), it
will default to CDMA mode instead.
05# Carrier on
Turn on the carrier.
05# turns the carrier on with a nominal value for the DAC
for an output power level.
06# Carrier Off
Turn off the carrier.