Motorola V8162, Service Manual

Page: 27 / 93

Identity and Security
07# RXMUTE Mute Recieve Audio
08# RXUNMUTE Unmute recieve audio
09# TXMUTE Mute Transmit audio.
10# TXUNMUTE Unmute transmit audio
11X# Loadsynth
Load the specified channel into the radio synthesizer.
X-Enter up to 4-digits for the channel number. Channel
numbers must be in the range of 1 to 1024.
Narrow mode channel numbers not currently supported.
12X# Set-Attn
In AMPS mode: Set the AMPS RF power attenuation to the
value specified (0-7).
In CDMA mode: Set the TX gain adjust DAC to the value
specified (0-255)
13# (not used)
14# STON Enables continuous signalling tone.
15# STOFF Disables signalling tone.
16#-18# (Not Used)
19# Version
Displays version corresponding to the two digit option x.
The following table show the valid options for x:
Decimal
00 Call processor
01 CDMA test command document number
02 Date
03 Time
22 DSP mask version
23 DSP patch version
- The call processor (factory version) number in the
format: 00 XXXX
- The CDMA test command document number: 01 XXXX
- The date the build was created in the format: 01JAN96
- The time the build was created in the format: xxyyzz
where xx is the hour, yy is the minute, and zz is the
second.
- The version of the DSP mask xxxxyyyyyyzzzz
where xxxx is the version, yyyyyy is the date, and zzzz is
the device.
- The version of the DSP patch xxxxyyyyyyzzzz
where xxxx is the version, yyyyyyis the date, and zzzz is
the device.
All data fields can be viewed by hitting the * key repeatedly.
To exit hit the # key.
Table 8:
Keypad
Entry
Command
Description
Status Display Result
Note: Use the PATH command (35A#) to select the audio path to test before using commands 07#
through 10#. (Default path is to internal speaker and microphone).