Motorola V8162, Service Manual

Page: 52 / 93

52 10/23/00
Refer to the disassembly instructions and
photo sequence on the following pages.
Assembly Procedure
Once the unit is disassembled and the repair
is carried out it then becomes obvious that to
assemble the unit, the procedure is the
reverse of that previously completed for dis-
assembly.
NOTE
Refer to Figure 6: “ST7760K Mechanical
Explosion” on page 76, as necessary, while
performing the disassembly/assembly proce-
dures.
Antenna Removal
Step 1. Turn off the telephone.
Step 2. Press down on the battery’s tab and
remove the battery from the housing.
Step 3. Use the antenna tool to remove the
antenna. Place the wide tip of the antenna in
the large opening of the antenna tool. Put the
bottom of the tool on the grooves in the base
of the antenna. Turn counterclockwise until
the antenna is free from the phone housing.
Housing disassembly:
Step 1:Battery Cover Removal.
With flat surface of bezel stick facing down,
place the black bezel tool at the rear housing
opening tab. Press gently downward and out
as shown in the picture. Remove the battery
cover.
Step 2. Light Guide Removal.
Using Light-guide extraction tool, align pin of
tool with left-hand side gap of battery retention
clip at the top right hand side of the battery
compartment. (Ensure not to damage clip). Place
the body of the tool flush with the right hand
edge of the battery compartment and flat to the
battery bed;