EWB100 Usage and Deployment Guide
Rev 1.13
Page 129
Appendix C: Utility Program
This section describes how to use a number of “utility programs” that are useful
with the EWB100
B.1 clientencrypttool
There is a Windows program for calculating encrypted values for WPA and CLI
configuration values. The program runs from a Windows Command Line. The
syntax is:
cliencryptool xxx
where xx is the value to be encrypted.
The program will calculate the encrypted form and print it out as a series of hex
digits, separated by a colon. The string, minus the colons, should be entered into
the CLI. Note that the encrypted form will be much longer than the input string
and will always contain only hex digits and be a multiple of 32 characters.
Also note if that if the following special characters are used in a password:
& | ( )
Then they must be escaped with the special character ^. The reason for this is
that the Windows Command Line interpreter uses these four characters for its
own purposes and so will not pass them to the program. By escaping them, they
will be passed to cliencryptool.
Summary of Contents for TEAM Badge (EWB100)
