44
Using additional handsets
10. Using additional handsets
Up to 5 handsets can be registered to one base station. Additional handsets
must be registered to the base before you can use them.
• The instructions described below apply specifically to the C5010A
handset. If you wish to register another manufacturer’s handset, the
instructions may vary. In this case, please refer to the instruction manual
of the additional handset.
• The System PIN is required to register or de-register handsets. The
default PIN is 0000.
10.1 Registering an additional handset
NOTE
Handset batteries must be fully charged before you start to register. Hold
your handset close to the base during the registration process. Handsets that
were supplied with your C5010A base are already registered.
On the base:
1. Press and hold
until the base emits a double beep. The base will
remain in registration mode for 90 seconds.
On the handset:
1. Press
Menu
, scroll to
Registration
and press
Select
.
2.
Register Handset
is highlighted. Press
Select
.
3. Bases are displayed. If necessary, scroll or to a new base you wish
to register the C5010A handset to and press
Select
.
4. Enter the system PIN and press
OK
.
5. The display shows
Searching Base X
.
6. When registration is successful the display shows
Handset Registered
and you
hear a confirmation beep.
NOTE
If registration is not successful the first time, please repeat the process again
in case the base registration period ran out of time. If the base is not found
after a few seconds, the handset returns to standby. Try registering again.
If there are already 5 handsets registered to the base, registration will fail.
You must de-register a handset before you can register a new one.
10.2 Register a different make of handset to your C5010A
base
IMPORTANT
DECT GAP Profile only guarantees that basic calling functions will work
correctly between different makes / types of handset and base. There is a
possibility that certain devices such as Caller ID will not work correctly.
