BSR 2000 Installation Guide
2-16
MGBI
526359-001
2.
Insert the center conductor of the coaxial cable into the small opening at the
center of the BSR 2000 wireless connector.
3.
Secure the connection by screwing the outside cable connector housing onto the
BSR 2000 wireless connector until finger tight; then, using a wrench, tighten the
connector one-quarter turn (15 in.-lbs when using a torque wrench).
Figure 2-11 Connecting a Cable to the Wireless Port
Setting up a Console Monitor
You must connect a terminal or a PC with terminal emulation software to the
BSR 2000 to perform the following tasks:
■
Supply the BSR 2000 with an IP address.
■
Configure the BSR 2000 (if you choose not to use a Telnet session).
To connect a console monitor to the BSR 2000 and communicate with it, complete the
following tasks:
Note:
To supply the BSR 2000 with an IP address, refer to the document,
BSR 2000 Configuration and Management Guide
, after you complete the
tasks described in this section.
US2
US1
US0
DS0
Win
Coaxial cable
US2
US1
US0
DS0
IF
bsr2k028
