Performing Installation Tasks
526359-001
MGBI
2-9
Connecting an Ethernet Cable to the BSR 2000
The BSR 2000 has built-in Ethernet network interfaces for connecting to a router,
switch, or hub. The RJ-45 ports for the Ethernet interfaces are located on the left side
of the rear panel. The ports numbers are color-coded in purple and labeled 0,1,2 and 3
as shown in
.
Figure 2-5 RJ-45 Ethernet Ports
To connect the BSR 2000 to the network, follow these steps.
1.
Connect a male shielded RJ-45 connector at one end of the cable to the assigned
Ethernet port on the router, hub, or switch.
2.
Connect a male RJ-45 connector at the opposite end of the network cable to one
of the four RJ-45 Ethernet ports on the BSR 2000.
Note:
To maintain regulatory compliance, use only shielded cables to
connect to the BSR 2000.
To Ethernet router,
switch, or hub
bsr2k005
0
1
2
3
4
5
Bits
RED
