8A
8B
01
02
03
04
19
20
21
24
25
22
23
EN
EN
04. INSTALLATION
04. INSTALLATION
AUTOMATISM INSTALLATION
AUTOMATISM INSTALLATION
03
• Place celling rail ‘s fixation plate roughly halfway through the steel rail as visible
in the pictures above.
05
• After rising the rail and mark the holes, you should fix the plate with screws.
After that, you should use bracket to reinforce the attachment, this time near the motor
(image 23).
06
• Attach the plates to the top of the
door panel. The rods must be centered
horizontally with the panel so that it stays
aligned with the rail.
It should also be to fixed as higher as
possible (picture 24).
07
• Now attach the two connecting rods
between the trolley and the panel’s upper
plate.
Use the screws and M8 nuts to tighten 2 rods
together (02 and 03), and 2 pins with pegs to
fix them on the trolley and the gate (01 and 04).
04
• Raise up the motor until the rail is
levelled horizontally.
If necessary, you should create a support
structure to a solid surface as shown on
the previous page, so that the rail stays
horinzotally aligned (picture 17).
Mark the holes in the ceiling plate and/or
structure and make the necessary holes
to fix it.
DETAIL 19
