6A
6B
09
11
10
12
EN
EN
CHANGING COURTESY LEDS
03. THE AUTOMATISM
04. INSTALLATION
INFORMATION PRE-INSTALLATION
CHANGING FUSE
• To replace the LED board you must open the top cover and detach the wire of the LED
from the control board. Loosen the screw which secures the LED board to the top cover
and remove it. Now just put the new LED board, screw it, fit the wire in the control board
and close back the cover on the motor.
• To replace the fuse, first loosen it as visible in the image 11. Then just pull to remove it
(image 12). Repeat the same steps in reverse order to put a new fuse.
The operator uses a 250V 2,5A.
For a correct operation of
ROSSO EVO
, you must take into account the following
parameters before the installation:
• Read all steps on this manual at least once in order to get acquainted with the
installation and configuration process.
• Make sure the door’s structure is solid and appropriate to be automated.
• Verify that the sectional door has no technical defects, such as friction points/
prison, that may jeopardize the automatism durability.
• Make sure the door is in good condition to install the motor. To do so, raise it
manually to 800mm, 1600mm and 2000mm from the ground. Check if the door remains
suspended in these positions or descending. If the door starts to go up or down, it
means that the springs are not well calibrated.
• Check the surroundings. Carefully evaluate any hazards that may cause material
damage, possible insects contact, infiltration, among others.
• Make sure that the automatism will be connected to a 230V, properly protected with
Ground Wire.
• Make sure there is adequate protection against short-circuits / power surges and
earthed in the Electrical Box.
• Be careful when handling directly the control board. Improper handling can damage
some electrical components.
• Make sure you have all the necessary material prepared for installation.
• Evaluate the safety devices to be installed. This will ensure that unexpected
accidents do not happen.
It is very important that these precautions are respected!
Only in this way the correct functioning and automatism durability can be achieved!
