7
9
d
c
b
a
7
d
5
b
c
a
8
D
RX
TX
EN
03. INSTALLATION
INSTALLATION
Make the cable connections in the following order:
Connection a:
TX Photocell (emitter) with Synchronization Cable;
Connection b:
Synchronization Cable with RX Photocell (receiver);
Connection c:
RX Photocell (receiver) with Connection Cable;
Connection d:
Connection Cable with Control Board (see page 8A);
Power the door control board and check the photocell Signaling Leds
(see page 9B).
Test the functioning of the system by carrying out an opening/closing
maneuver, verifying that the photocells do not interfere with the normal
movement of the door.
Then repeat the maneuver and place yourself in the area protected by
the photocells and check if it reverses the direction of maneuver.
SYNC CABLE
Pass the photocell cables through holes centered with the supports (
B
)
of each column, in order to make the connections between them and
with the control board.
This way, they will be hidden by the covers (D).
Replace the covers (
D
) on the supports (
B
) and fasten with the screws.
• MAKE THE CONNECTIONS
• TEST SYSTEM OPERATION
5
7
6
8
9
