motorini XO 125, User Manual

Page: 8 / 28

Instruments
Warning:
Do not wash the surface with high pressure water.
Do not wipe the surface solvent based products as
the surface will crack and discolor.
Speedometer (1)
This indicates the speed in MP/H and KM/H
Odometer (2)
This registers the total distance that the motorcycle has covered in KM
High beam (3)
This is the high beam indicator light allowing the rider to see he has high beam on or
off.
F/I Warning lamp (4)
F/I warning light should illuminate when ignition switch is turned from “
” to
“ ” .The F/I warning light will extinguish when the vehicle is running. If the F/I
warning light is flashing it means there is a fault and you should contact your
supplying dealer.
Turn signal indicator light switch (5)
Sliding the switch to the “ ← ” position will flash the left turn signal . Moving the
switch to the “ → ” position will flash the right turn signal . Press the center of the
switch to extinguish all turn signals.
Fuel gauge (6)
The fuel gauge needle indicates the tank is empty with E or F indicates the tank is full.
If the fuel gauge needle goes to the red area you must refuel as soon as possible.
Clock (7)
This shows the time. Adjust the clock by pressing both buttons simultaneously till the
numbers flash, press the left button till the required hour is shown. Select minutes by
pressing the right button , Press the left button until the required minutes are shown.
Press both button simultaneously to set the clock.
Left handlebar control system (Pic4/6)