Replacement of the light bulbs
Broken bulbs should be replaced by those of the rated parameters as shown in the table
below. Otherwise it will cause overload of the circuit and earlier breakage of bulbs.
Head lamp
12V
35W
Tail/Braking lamp
12V
3W/10W
Turn signal lamp
12V
10W
Headlamp Bulb
Remove the headlamp bulb in the following way:
①
Remove the two screws below the headlamp cover and take out the reflector unit.
②
Move away the rubber gasket , remove the long spring and take out the bulb socket.
The headlamp aim can be adjusted by turning upwards or downwards when needed.
Turning light
①
Remove the two screws to take off the light cover.
②
Press the bulb and turn it to the left to remove it.
③
Put in a new bulb and press and turn it to the right to fit it in.
CAUTION
—
Do not tighten the screws too hard when fastening the cover as this may cause
damage to the cover.
Tail/Braking light
The tail/braking light bulb shall be replaced as follows when needed:
①
Remove the two screws and take off the light cover.
②
Press and turn the bulb leftward to disengage if from the pin and take it out.
③
Press a new bulb into the socket and turn it rightward.
CAUTION
—
Do not tighten the screws too hard when fastening the lamp cover as this may
cause damage to the cover.
Summary of Contents for XO 125
Page 1: ...XO 125 User s Manual...
Page 28: ...Wiring Diagram...