Chapter 2
Using your CL910
Using speech recognition 46
Setting up speech recognition
Before you can use speech recognition, you must configure the microphones and train the
system for the characteristics of your voice. Then, you can take the available speech tutorial
to learn basic voice commands.
Set up the microphones
For best results, move to a quiet environment.
To set up the microphones:
1. In the Control Panel, tap the
Ease of Access
category, then tap
Speech Recognition
.
2. Tap
Set up microphone
.
3. If you are using the tablet’s microphone array, select
Other
.
4. Follow the instructions in the setup program.
5. If the microphones are set to an appropriate level, the meter will stay in the green zone
while you read the sentences. If the level is too low or too high, use Motion Dashboard to
adjust the level (see
Using the Motion Dashboard
on page 16).
Train your tablet to recognize your speech
Use this procedure to improve your tablet’s ability to understand your voice.
To train your tablet to recognize your speech:
1. In the Control Panel, tap the
Ease of Access
category, then tap
Speech Recognition
.
2. Tap
Train your tablet to better understand you
.
3. Follow the instructions in the setup program.
Taking the speech tutorial
You can use the speech tutorial to learn basic commands and dictation. The tutorial takes
about 30 minutes to complete.
To take the speech tutorial:
1. In the Control Panel, tap the
Ease of Access
category, then tap
Speech Recognition
.
2. Tap
Take Speech Tutorial
.
3. Follow the instructions in the tutorial program.
Using dictation and voice commands
After you have set up speech recognition, you can open it from the Control Panel.
To use Dictation and Voice Commands:
1. In the Control Panel, tap the
Ease of Access
category.
2. Under
Speech Recognition
, tap
Start Speech Recognition
.
