Motec LTC, User Manual

Page: 2 / 42

2 Introduction
Introduction
MoTeC LTCs (Lambda to CAN) monitor and control Wideband Lambda
sensors and transmit Lambda readings and diagnostics on a CAN bus. There
are single channel LTC and Dual channel LTCD available to suit either Bosch
LSU4.9 or NTK sensors:
•
#61300 – Single Channel Bosch LSU 4.9 Sensor
•
#61301 – Dual Channel Bosch LSU 4.9 Sensors
•
#61304 – Single Channel NTK Sensor
•
#61305 – Dual Channel NTK Sensors
Up to 32 Lambda sensors can be configured on a single CAN bus using LTCs,
allowing an ECU or Data Logger to simultaneously monitor multiple Lambda
sensors.
Throughout this manual the LTC, LTCD, LTC-NTK and LTCD-NTK will be
referred to as LTC except where details specific to a particular model are
discussed.
Features
•
Accurate Lambda measurement even when the exhaust gas temperature
is changing rapidly (heating or cooling)
•
Ability to perform free air sensor calibration or use the initial sensor factory
calibration. LTC-NTK has the ability to be calibrated against a test gas.
•
Pre-configured to work in a single LTC or LTCD installation, without
requiring configuration with a PC
•
LTC Manager software to:
o
configure and calibrate all LTCs on the CAN bus
o
display readings and diagnostics
o
configure the CAN transmission address of each LTC
o
control free air calibration
o
update LTC firmware
Compatibility
•
MoTeC ‘Hundred Series’ ECUs: M400, M600, M800 and M880
•
MoTeC M1 Series ECUs
•
MoTeC Data Loggers: ACL, SDL, SDL3, ADL, ADL2, ADL3, CDL3 and all
C Series colour Display Loggers (C187 etc.)