MoTeC
Operation
27
•
Select Adjust > Sensor Setup > Input Setup... to open the Input Pins Setup
dialog.
•
Attach an LTC reading to a channel, using the following parameters
Input Source
Predefined Calibration
PLM 1 to PLM 12
#81 Lambda: PLM over CAN
Example 1: LTC1 reading assigned to channel Lambda 1
Example 2: LTC1 to LTC4 readings assigned to Lambda Cyl channels
Assign Lambda measurements to a M84 channel
For an M84 the Lambda Input Source is fixed so only the Calibration needs to
be chosen – Predefined “#81 Lambda: PLM over CAN”
Summary of Contents for LTC
Page 34: ...34 Appendices Appendix C Dimensions...
Page 35: ...MoTeC Appendices 35...
Page 36: ...36 Appendices...
