Step 5 — Loading Filament and Starting Print
Palette will initialize, before prompting to load filament into the inputs.
Preheat printer while Palette produces splices.
Once Palette is done creating the initial splices, there should be about an inch of filament coming
out of the outgoing tube. Insert this filament end into the extruder, and use the printer's
screen/controls to drive filament forward.
Once the filament is gripped by the extruder’s gears, jog the filament to insert the tube end into
the clip grommet.
Jog the remaining filament prompted on Palette’s screen, by using the printer's screen/controls
to drive the filament forward/
Clear the purged filament from the nozzle, and tap “finish” on Palette.
Start the G-Code on the printer.
Accessory Mode with Palette 3
61 of 74
