Mortara Quinton CR60, User Manual

Page: 55 / 62

RECEIVING AND INSTALLATION
47
c. Hold down
Stop Belt
and press the + or - key until the correct configuration number appears in the center
display.
Caution.
The configuration must be set to CP1 or CP3. Do not attempt to use any other configuration.
d. Press Select to store the configuration.
e. Exit the service mode by simultaneously pressing
Stop Belt, Slower,
and
Faster
.
16.
Test all operational functions, including speed, grade, timer, and parameters using the following section.
Testing the Treadmill and Controller
WARNING! Falling hazard.
While performing steps 1 through 7 do not stand on the treadmill.
1.
Press the
Power
key on the controller. Within seconds, the Enter Weight LED should light up and the Enter Wt
message should flash in the center display.
2.
Press the Start Belt key. Verify that the treadmill accelerates gradually to minimum speed.
3. Press and hold the Down key until the treadmill reaches zero grade.
4. Press the
Up
and
Faster
keys until the treadmill is running at maximum speed and grade.
5. Let the treadmill run for 15 minutes.
6. Watch the walking belt carefully to ensure that it does not drift left or right. Listen for unusual noises, such as
squeals or squeaks.
7. Press the Slower key until the treadmill belt is moving at a reasonable speed for walking.
8. Walk on the moving belt and verify proper operation at representative speeds and grades. If the walking belt
slips, but the front roller turns, adjust the walking belt tension.
9. When the test is finished,
a. Press Down until the treadmill is at zero grade.
b. Press
Stop Belt
.
c. Press Power to turn off the controller.
If the treadmill does not run smoothly, contact an authorized technician before using it.