Mortara Quinton CR60, User Manual

Page: 53 / 62

RECEIVING AND INSTALLATION
45
Figure 9 Placing Hood on Treadmill
5.
Slide the hood forward while holding it in the tilted position. (Spread the hood apart slightly to clear the
upright.)
6.
Lower the hood, aligning the slots in the bottom of the hood with the screws in the side rails (previous figure).
7. With the screws engaged in the slots, slide the hood forward approximately 1/2-inch and tighten it in place.
8. Align the two holes inside the front of the hood with the holes in the side rail. Install a star washer onto the two
1/4-20 x 1-in Phillips-head screws supplied with the treadmill, then use the screw to fasten the hood to the
frame.
Due to regulatory requirements in some countries, your treadmill may have a grounding bracket attached to
each upright. Use the two #10 self tapping screws provided to connect the brackets to the treadmill hood.
Figure 10 Grounding brackets, Step 8