Mortara ELI 10 Rx, User Manual

Page: 64 / 72

APPENDIX A
40
Test Operation
After cleaning and inspecting the ELI 10 Rx, proper operation of the unit may be confirmed by using an ECG
simulator to acquire and print a standard 12-lead ECG of known amplitude. Waveforms should appear normal, with
proper amplitude, and without distortion or excessive noise.
Recommendations to Biomedical Staff
Following any service to the ELI 10 Rx and docking station or when non-compliant operation is suspected, Mortara
Instrument, Inc. recommends the following procedures:

Confirm proper operation.

Perform testing to ensure continued electrical safety of the device
(use IEC 60601-1, ANSI/AAMI ES 60601-1, or IEC 62353 methods and limits).
o
patient leakage current
o chassis leakage current
o
earth leakage current
o
dielectric strength or insulation resistance (mains and patient circuits, mains and signal input/output
part (e.g., USB), mains and protective earth)
Battery Maintenance
The ELI 10 Rx houses an internal lithium ion battery.

Operating time on a full battery charge (ECG acquisition only): approximately 8 hours

Maximum time to fully recharge battery: approximately 4 hours

Typical AC power consumption of hand held + docking station: idle mode : battery already charged;
acquiring ECG: 4.5W

Typical AC power consumption of hand held + docking station: charging : full charging current, acquiring
ECG: ~20W

Maximum AC power consumption of hand held + docking station: full charge current, GSM/GPRS mobile
transmitting, max USB power: ~35W
Mortara Instrument recommends that the ELI 10 Rx be connected to the docking station for recharging when not in
use. To maintain optimal battery capacity, occasionally use the device without recharging until it reports “BATT
LOW,” then recharge again immediately.
For information about replacing the battery, please refer to the ELI 10 Rx service manual.
Calibration of the ELI 10 Rx
The ELI 10 Rx is calibrated at the factory. No user adjustment or periodic recalibration is required.