Mortara ELI 10 Rx, User Manual, Page: 54 / 72

SECTION 6
30
Filter
The ECG plot-frequency filter (or print filter) can be set to 40 Hz, 150 Hz, or 300 Hz. The plot-frequency filter does
not filter the acquired digital record. A 40 Hz plot-filter setting will reduce the noise (40 Hz and higher frequencies)
on the printed ECG; a 150 Hz plot-filter setting will reduce the noise (150 Hz and higher frequencies) on the printed
ECG; a 300 Hz plot-filter setting will not filter the printed ECG. The filter setting is printed at the bottom right
corner of the ECG printout.
WARNING: When the 40 Hz filter is used, the frequency response requirement for diagnostic
ECG equipment cannot be met. The 40 Hz filter significantly reduces high-frequency components of the
ECG and pacemaker spike amplitudes, and is recommended only if high-frequency noise cannot be reduced
by proper procedures.
LCD ECG Speed
Defines the speed in which the ECG will be presented on the display. To manually set the speed, select
F3 ( ► )
and
this will toggle you between 5, 10, 25, or 50 mm/sec display sweep speed.
Ht/Wt (Height/Weight) Units
Defines the units of weight and height to either pounds/inches (lb/in) or kilograms/centimeters (kg/cm).
Date Format
Select either U.S. or European format for entering and displaying the patient’s date of birth.
For example:
July 16, 2007 is displayed as follows:
U.S. Date Format:
MM/DD/YYYY (07/16/2007)
European Date Format
: DD.MM.YYYY (16.07.2007)
Interpretation (optional)
The ELI 10 Rx automatically analyzes ECGs. This setting allows you to select or suppress the “interpretive” text on
the ECG report at the E-Scribe. You may also choose to send the data to the ELI LINK and review the ECG with
interpretation in a PDF format.
NOTE: A qualified physician should review the computer-generated ECG interpretation before the
treatment of any patient.