Morgana Plockmatic BM 60, Service Manual

Page: 16 / 37

15
REP 3.9 ADJUSTMENT STAPLER PRESSURE
Purpose
It is possible to staple through 22 sheets of paper without adjusting the stapler
pressure. The stapler pressure should increase when thick sets are stapled.
To make this possible a piece of spring steel is mounted underneath the stapling
bracket. If stapler pressure is incorrect adjusted, staples will be loose when
stapling two sheets.
To check do the following steps:
Switch off the main power switch and disconnect the power cord.
Remove Infeed cover, according to CRI 2.2.
Empty the Stapler magazines.
Press on top of the Stapler bar until the Stapler heads are fully compressed.
Check that the distance is 9 mm from the stapler Motor crank to the plastic
Crank arm.
1.
2.
3.
4.
5.
Adjustment
Loosen the screws (1).
Position the stapler yoke bracket to obtain the 9 mm and tighten the screws.
1.
2.
9 mm
Plastic crank arm
Motor crank
Stapler motor
Press here
Stapler bar
Stapler yoke
bracket
Stapling bracket
Stapler motor
1
1