Morgana Plockmatic BM 60, Service Manual

Page: 12 / 37

11
REP 3.5 PARALLELISM STAPLE STOP - ANVILS
Purpose
The purpose is to obtain the correct staple position.
Switch off the main power switch and disconnect the power cord.
Empty Stapler magazines.
Insert tool B according to the drawing and crank hand wheel to position upper
edge of tool at Anvils.
CAUTION: The clear Indicator switch could be damaged when inserting tool B.
1.
2.
3.
Adjustment
Loosen one of the screws at position (1) and two of the screws at position (2).
Adjust by skewing the staple stop carriage until tool B is aligned with the anvils.
Tighten the screws at position (1) and (2).
NOTE: If further adjustment is necessary to align tool B with the anvils, also loosen
screw (3).
1.
2.
3.
3
VIEW FROM TOP SIDE
1
Staple stop
2
Tool B
Anvil bar