Operating the Digifold
To operate the motors manually, switch the machine ‘on’ at the Emergency Stop switch.
Whilst holding down Push Button 1, flick the Set-up switch to ‘set up’.
The display will now read
Press the System switch to ‘on’ and use Push Button
1 (forward) and Push Button 2 (reverse) to manually rotate the rollers in short pulses.
Rotate the rollers until the grub screw is located. Lift the exit guard and the machine will
switch ‘off’ automatically. Loosen the drive wheels and hubs by using a 2mm allen key.
Arrange the drive wheels and hubs as shown in FIG 18.1. In order to avoid marking on
some types of media ensure a gap between the drive wheels and drive hubs.
‘hAndLE’.
Setting the extension table
The extension table can be fixed to the machine in order to feed through longer sheets.
The table can be supported by the two fixing screws as shown on page 4.
The back stop can be used to support the paper stack as shown in FIG 18.2 below.
The other back stop supplied with the machine can be used as a tool holder as shown in
FIG 18.3 below.
Page 19
SYSTEM
Digifold
