Operating the Digifold
6.
Turn the Setting Dial clockwise to select
7.
Hold down PB1or PB2 and turn the Setting Dial to adjust the crease position in
10.0mm or 0.1 mm increments. Release PB1 or PB2.
(this can be done on all further crease positions)
11.
Set the Delivery Conveyor System as described on page 20.
12.
Adjust the Batch Count as described on page 21, if required.
13.
The program settings can now be stored, if required, as described on page 22.
14.
Run the job by switching the System and Compressor switches on, then
switch the Feed switch on.
to 0.5 for PAPEr
type 1, 1.0 for PAPEr type 2 and 1.5 for PAPEr type 3.
‘1 cr’
If the fold option F2 is not required for the job being set up, it must be set to ‘0’
F1
8.
Turn the Setting Dial clockwise to
etc. (there are 9 crease positions in total)
Note:- the crease positions
increase upwards. (i.e.
must be less than
,
must be less than
etc)
9.
Continue turning the Setting Dial clockwise to
.
10.
Hold down PB1 or PB2 and turn the Setting Dial to adjust the fold position in 10.0mm
or 0.1 mm increments. Release PB1 or PB2 and turn the Setting Dial clockwise.
is the last fold position.
Note:- the fold positions may be in any order. (i.e.
can be larger than
)
Once the
has been selected, if returned to
the default
length of 100 will be found and any previous settings will be lost unless stored.
If “fold off” is selected then both knives will go to the double deflect settings which
are determined by the paper type setting.
If in “set by fold” and doing a Half fold then the 1st knife will be set to the deflect
position which is determined by the paper type setting.
When using
if only one fold is required,
set this on
and
set
at 0.0. If the leading edge of the sheet buckles up, adjust
‘2 cr’
‘1 cr’
‘2 cr’ ‘2 cr’
‘3 cr’
If any of the nine available crease options (’1 cr’ to ‘9 cr’) are not required for
the job being set up, they must be set to ‘0’
‘F1’
‘F2’
‘F1’
‘F2’
Set by Position
Set by Fold
Set by Position
always
F2
F1
must
NOTES:-
Deflect knife position.
Page 15
SYSTEM
Digifold
