Trouble Shooting
Page 41
SYSTEM
AutoCreaser Pro 50
l
l
l
Check that the air distribution has been correctly set.
Check that the air separation has been set high enough to feed the sheets.
For heavy stocks, very small or very large sheets, embossed or even irregular stock,
it may be required to feed the sheets manually - see page 29 for instructions.
Open the exit and remove the blade set
(see pages 37-39) to access the dual
sensor post located in between the drive
rollers. Using a soft brush, clean the
visible sensor on the end of the post.
Use the brush to clean the sensors
between the post and the bottom paper
guide which are not visible.
Photograph (left) shows the dual sensor
post containing the sensors.
If paper gets jammed under the paper gate the vacuum drum will stop rotating, this is a
safety feature. Remove the paper and re-adjust the paper gate.
Machine not counting
Paper jammed under paper gate.
