The Blade Assembly
Page 35
SYSTEM
Adjusting the blade pressure (no paper required)
1. (i) Switch the power ‘on’ by turning the Emergency stop button clockwise to release the
safety latch.
(ii) Select the Tools tab
at the bottom of the touch screen, the display will
change to that shown below.
(iii) Select the up arrow to move the blade to the Top Dead Centre position.
2. Raise the exit guard
3. Using a 6mm allen key, unlock the shoulder bolts (labelled with scale transfer)
positioned at each end of the creasing blade.
4. Turn the adjustment cam to adjust the blade pressure. Increasing the gradient on the
scale will increase the blade pressure.
5. Ensure that the shoulder bolts are locked after setting.
The diagram below demonstrates the adjustment of the blade pressure
AutoCreaser Pro 50
Click on Up Arrow to
put Anvil into Top
Dead Centre position
(TDC)
