10
User Action
System Response
Select one of the following three options:
• Say the next group of digits in the number (e.g.
“454,”“1212” etc.)
• Or Say
“Clear”
• Or Say,
“Dial”
The system will add the new digits to the number
and prompt
“Complete the number, say Clear or
say Dial“
followed by a BEEP
The last series of digits you entered will be erased.
The system will respond,
“Block Cleared”
followed
by a BEEP and you can then enter more digits.
“Dialing”
Press
when call is completed
“Phone call completed.”
Placing a Call Using Your UConnect Phonebook
The
“Call”
command is used to dial phone numbers pre-stored in the UConnect phonebook
(See
UConnect phonebook functions
section). To place a call using the UConnect phonebook,
please follow these steps:
User Action
System Response
Press
“Ready.”
BEEP
Say
“Call”
“Who would you like to call?” BEEP
Say
“[Name]”
“Please say a location [home, work, cellular, or
pager]”
[System will list all stored locations for
name.] BEEP
Say
“Home,”“Work,”“Cellular,” or “Pager”
(if more than one location per name is stored)
“[Name] [Location]” Is this correct?”
BEEP
Say
“Yes”
“Dialing”
[System dials phone number]
Press
when call is completed
"Phone call completed."
NOTE: The phonebook entries are stored in the UConnect System and not in your wireless telephone.
Any numbers stored in your wireless phone may directly be accessible through the UConnect system if
supported by your wireless phone. To access this wireless phone feature, press and hold
button for at
least 3 seconds and follow the instructions in your wireless phone owner's manual.
11
Wireless Phone Indicators
Your UConnect System will alert you to many wireless telephone issues that might impair operation.
Following is a list of system prompts and the wireless phone conditions that initiates the prompt:
System Prompt
Wireless Phone Condition
“Phone battery low”
The user’s wireless phone battery is low and should
be recharged soon.
“Cellular connection weak.”
The wireless phone has a weak connection to the
service provider’s wireless network. This may result
with a poor audio connection or the call being
dropped.
“Roaming”
The user may be using a roaming wireless phone
connection.
“No cellular connection”
There is no available wireless network to complete
the call however, the system will continue to dial
the call.
“Phone not connected”
There is currently no wireless phone connected
to the UConnect System. The user must pair
a compatible wireless phone to the UConnect
System. [Refer to Pairing Your Wireless Phone
section ]
“Currently paired phone does not support
this function."
The version of Bluetooth
TM
software in the user’s
wireless phone does not support the desired
function.
Ending a Call
To end a call, follow these steps:
User Action
System Response
Press
“Phone call completed.”
NOTE: If you do not press
at the conclusion of your call, the call will eventually terminate and the
“Phone Call Completed”
prompt will be heard. This could result in additional wireless service charges to
the user.
