10
73. Position the lower C-pillar trim panel (4) to the C-pillar and
engage the retaining tabs that secure the trim panel to the
C-pillar.
74. Keeping the inner bottom end of the upper C-pillar trim panel
(2) away from the cab back trim panel, slide the upper retaining
tab (1) of the trim panel into the hole in the C-pillar and engage
the retaining tabs (3) that secure the trim panel to the C-pillar.
Club Cab, With Rear Jumper Seats
75. Position the lower C-pillar trim panel (7) in the vehicle.
76. Route the seat belt, lower anchor, latch plate and turning loop
(3) through the slots provided in the lower C-pillar trim panel.
Verify that the seat belt webbing between the retractor and the
lower anchor is not twisted.
77. Position the seat belt lower anchor to the mounting hole in the
fl
oor panel near the base of the C-pillar and Install the screw
(6) that secures the lower anchor to the
fl
oor panel. Tighten
the screw to 39 N·m (29 ft. lbs.).
78. Position the lower C-pillar trim panel to the C-pillar (1) and
engage the retaining tabs that secure the trim panel to the
C-pillar.
79. Keeping the inner bottom end of the upper C-pillar trim panel
(2) away from the cab back trim panel, slide the upper retaining
tab of the trim panel into the hole in the C-pillar and engage
the retaining tabs that secure the trim panel to the C-pillar.
80. Engage the upper edge of the trim cover (4) over the top of
the turning loop. Then, squeeze the lower end of the trim
cover and the turning loop together
fi
rmly and evenly until the
engagement tabs of the trim cover snap into the slots of the
turning loop.
Club Cabs
81. Position the seat belt turning loop (3) to the mounting hole
in the upper C-pillar trim panel and install the screw (5) that
secures the seat belt turning loop to the C-pillar. Tighten the
screw to 39 N·m (29 ft. lbs.).
4/1/2008
K6860274 Rev. 1
