Moog Components Group
Mini4, Rev C
February 23, 2009
(201580-xxx And 201590-xxx)
Page 6 of 19
D37 (Green)
Located on the left bottom of the board, section labeled ‘VID #4’, provides an
indication of the presence of an input signal on video channel #4. When ‘ON’
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
Bottom of Board
LED
Indication
D10 (Green)
Located on the upper right corner of the board, labeled RMT LINK LED. ‘ON’
when the link is established with the remote M4 Video Output board and the data
stream is synchronized
D13 (Green)
Located on the upper left corner of the board, RS-485 Diagnostics Interface. Blinks
ON/OFF with PMON II accesses to the board.
D14 (Green)
Located on the upper right corner of the board, labeled LOCAL LINK LED. ‘ON’
when the link is established with the remote M4 Video Output board and the data
stream is synchronized
D17
(Red/Green)
Located on the upper right of the board. Green is ‘ON’ when serial data is being
received into the board on channel 6, Red is ‘ON’ when serial data is being
transmitted out of the board on channel 6.
D21(Green)
Located on the upper left corner of the board, labeled ‘TD’. ‘ON’ when RS-485
Diagnostics data is being transmitted out of the board.
D22
(Red/Green)
Located on the upper right of the board. Green is ‘ON’ when serial data is being
received into the board on channel 5, Red is ‘ON’ when serial data is being
transmitted out of the board on channel 5.
D23
(Red/Green)
Located on the upper right of the board. Green is ‘ON’ when serial data is being
received into the board on channel 4, Red is ‘ON’ when serial data is being
transmitted out of the board on channel 4.
D25
(Red/Green)
Located on the upper right of the board. Green is ‘ON’ when serial data is being
received into the board on channel 3, Red is ‘ON’ when serial data is being
transmitted out of the board on channel 3.
D26 (Green)
Located on the upper left corner of the board, labeled ‘RD’. ‘ON’ when RS-485
Diagnostics data being received into the board.
D28
(Red/Green)
Located on the upper right of the board. Green is ‘ON’ when serial data is being
received into the board on channel 2, Red is ‘ON’ when serial data is being
transmitted out of the board on channel 2.
D30
Located on the upper right of the board. Green is ‘ON’ when serial data is being
