Moog Components Group
Mini4, Rev C
February 23, 2009
(201580-xxx And 201590-xxx)
Page 10 of 19
the remote unit.
D6 (Green)
Labeled ‘2.5V’, located on the mid-right of the board. When ‘ON’ indicates the on-
board 2.5V converter is operational
D7 (Green)
Not labeled, located on the bottom center of the board. When ‘ON’ indicates that 5V
is available to the display LED ribbon header.
D8 (Green)
Labeled ‘5V’, located on the lower right of the board. When ‘ON’ ind5V dc
is available to the board
D9 (Green)
Labeled ‘3.3V’, located at bottom center of the board. When ‘ON’ indicates 3.3V is
available on the board.
D31 (Green)
Located on the left middle of the board, section labeled ‘VID #1’, provides an
indication of the presence of an input signal on video channel #1. When ‘ON’
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
D32 (Green)
Located on the left middle of the board, section labeled ‘VID #2’, provides an
indication of the presence of an input signal on video channel #2. When ‘ON’
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
D35 (Green)
Located on the left bottom of the board, section labeled ‘VID #3’, provides an
indication of the presence of an input signal on video channel #3. When ‘ON’
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
D34 (Green)
Located on the left bottom of the board, section labeled ‘VID #4’, provides an
indication of the presence of an input signal on video channel #4. When ‘ON’
indicates that this board has approximately 1.0Vp-p input signal (either video or
analog signal).
Bottom of Board
LED
Indication
D10 (Green)
Located on the upper right corner of the board, labeled RMT LINK LED. ‘ON’
when the link is established with the remote M4 Video Output board and the data
stream is synchronized
D13 (Green)
Located on the upper left corner of the board, RS-485 Diagnostics Interface. Blinks
ON/OFF with PMON II accesses to the board.
D14 (Green)
Located on the upper right corner of the board, labeled LOCAL LINK LED. ‘ON’
when the link is established with the remote M4 Video Output board and the data
