16
17
Preparing the Destination Controller to Receive Data
First, it is necessary to place the destination controller into a receiving state. If your destination
controller is also a REVOLUTION Remote Control, follow the steps below.
On your destination controller:
If you’re not already at the Home screen, press the
1.
button to move back one screen
at a time until the only two choices appearing are Monster and Add Device.
Use the
2.
or
button to highlight Monster.
Press and hold the
3.
key
shift
button for 3 seconds. The menu changes and Nodes is highlighted.
Use the
4.
or
button to highlight Transfer (a seventh menu choice not displayed among
the first three) and press the
button.
On the next screen, use the
5.
or
button to highlight Receive (the third menu choice
of three) and press the
button.
The screen displays RECEIVING. This means your destination controller is ready to receive
6.
data from your source remote.
NOTE:
To place a destination controller into receiving mode that is not a REVOLUTION Remote
Control, follow the instructions in the manual that came with it. Do so before you perform the
Copy Option commands on your source remote as described in the next section.
COPYING DATA FROM THE SOURCE REMOTE
Before you follow the steps for your preferred Copy Option, make sure you place the source
remote and destination controller 3 to 5 inches apart.
Copy Option 1: Create Secondary Controller – Entire REVOLUTION 200
On your source remote, follow the same steps 1 to 4 you just performed on your Destination
1.
controller (see Preparing the Destination Controller to Receive Data).
On the next screen, use the
2.
or
button to highlight Create Secondary and press
the
button.
On the next screen, use the
3.
or
button to highlight Entire Rvltn 200 and press the
button. The source remote screen will say SENDING and the destination remote screen will
say RECEIVING.
If the copy succeeds, the source remote screen will say SUCCESS. Otherwise, it will read FAIL.
4.
Copy Option 2: Create Secondary Controller – Network Only
On your source remote, follow the same steps 1 to 4 you just performed on your Destination
1.
controller (see Preparing the Destination Controller to Receive Data).
On the next screen, use the
2.
or
button to highlight Create Secondary and press
the
button.
On the next screen, use the
3.
or
button to highlight Network Only and press the
button. The source remote screen will say SENDING and the destination remote screen will
say RECEIVING.
If the copy succeeds, the source remote screen will say SUCCESS. Otherwise, it will read FAIL.
Copy Option 3: Controller Swap – Entire REVOLUTION 200
Performing this command copies all data: network, scenes and node settings.
On your source remote, follow the same steps 1 to 4 you just performed on your Destination
1.
controller (see Preparing the Destination Controller to Receive Data).
On the next screen, use the
2.
or
button to highlight Controller Swap and press
the
button
On the next screen, use the
3.
or
button to highlight Entire Rvltn 200 and press the
button. The source remote screen will say SENDING and the destination remote screen will
say RECEIVING.
If the copy succeeds, the source remote screen will say SUCCESS. Otherwise, it will read FAIL.
Copy Option 4: Controller Swap – Network Only
Performing this command copies all node information but does not copy any scenes.
On your source remote, follow the same steps 1 to 4 you just performed on your Destination
1.
controller (see Preparing the Destination Controller to Receive Data).
On the next screen, use the
2.
or
button to highlight Controller Swap and press
the
button
On the next screen, use the
3.
or
button to highlight Network Only and press the
button. The source remote screen will say SENDING and the destination remote screen will
say RECEIVING.
If the copy succeeds, the source remote screen will say SUCCESS. Otherwise, it will read FAIL.