Dishwasher Installation
STEP 25
LITERATURE
• Be sure to leave complete literature package, these Installation
Instructions and product samples and/or coupons with the
consumer.
STEP 23
REPLACE TOEKICK
• Place toekick against the legs of the dishwasher.
• Align the toekick with the bottom edge and make sure it is
against the floor.
• Insert and tighten the 2 toekick attachment screws. The
toekick should stay in contact with the floor.
Tip: Reduce sound from under the dishwasher. Make sure
toekick is against floor.
Figure AJ
Attachment
Screws
Toekick
Control Box
Figure AG
Figure AH
STEP 24
CHECK THE FOLLOWING
• Tub trim does not interfere with the door
• Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door
• All 4 legs of the dishwasher are firmly in contact with
the floor
• Drain hose is not pinched between the dishwasher and
adjacent cabinets or walls
• Tub trim is fully seated on the tub flange
NOTE:
While performing installations described in this book, safety glasses or
goggles should be worn.
For Monogram
®
local service in your area, call 1.800.444.1845.
NOTE:
Product improvement is a continuing endeavor at General Electric.
Therefore, materials, appearance and specifications are subject to change
without notice.
Appliance Park
Louisville, KY 40225
Monogram.com
Push the sides of the insulation behind
the toekick attachment screw holes
(on some models)
STEP 22 POSITION SOUND
INSULATION PIECE
(on some models)
• Locate the sound insulation package inside the dishwasher.
• Stand the parts upright as shown.
• Locate the control box.
•
Push insulation block portion under the dishwasher until it
is beneath the control box.
• Push the panel portion up to the front of the block.
• Tuck the sides of the front panel behind the toekick
attachment screw holes.
Toekick
Insulation Block
(On some models.)
Dishwasher
Door
Figure AF
STEP 22 POSITION SOUND
INSULATION PIECE
(on some models) (CONT.)
• Open door all the way, if the door doesn’t stay fully open,
adjust the insulation panel.
• Align the screw holes with the screw holes on the legs of
the dishwasher.
• Ensure vent opening is not blocked by insulation.
Vent opening
Location and appearance will vary
