Mono DELTA DEPOSITOR 40, Operating And Maintenance Manual

Page: 10 / 38

Delta softstart RevB17 26-9-17
10
CAUTION SHOULD BE TAKEN WHEN REMOVING HOPPER ASSEMBLY AS
WEIGHT EXCEEDS 25KGS.
6 Unscrew the nuts holding the pump end cap to the hopper. Ensure that the nuts
are placed where they will not be lost.
7 Withdraw the end cap with the pump gears, if still attached. Ensure that the ‘0’
sealing ring on the inside of the endplate is not damaged during cleaning.
NOTE: Use only warm soapy water to clean these parts that should be rinsed and
thoroughly dried before reassembly. The greatest care must be taken not to
drop the hopper, or leave any components in the hopper. After washing, the
component parts should be allowed to cool before attempting reassembly.
8 Reassembly is reversal of above procedure.
TABLE REMOVAL AND CLEANING
1 Removal of the table from the machine for cleaning is not necessary, however,
if required, unscrew the two securing screws from the side of the table and
slide table off support bars - the drive shaft will disengage from its coupling as
the table is removed.
To replace, follow reverse procedure ensuring drive shaft engages properly with
its coupling.
2 In normal use clean the table’s external surfaces and belts with warm soapy
water and rinse and thoroughly dry before use.
3 The table’s conveyor belts can be disengaged from their drive rollers by
slackening the adjusting screws on the underside of the table. However, for belt
replacement first remove the table from machine as in 1 above.
END CAP O-RING TABLE RETAINING
SCREWS
TABLE DRIVE COUPLING BOLT ADJUSTING SCREWS