Mono DELTA DEPOSITOR 40, Operating And Maintenance Manual

Page: 12 / 38

Delta softstart RevB17 26-9-17
12
FITTING OF ROTARY TEMPLATES
These units are used for the manufacture of circular products.
The straight rotary holder(s) are used, for whirls.
Offset rotary holder(s) are used for such products as meringue rings.
1 Hinge and prop up front and rear hopper guards
2 Select template, nozzle holder and nozzle required.
3 Screw nozzles into offset or straight rotary holder.
4 Insert nozzle holder into template ensuring that they are pushed fully into
seatings.
5 Slide template into matching recess at base of hopper pump until gear teeth
mesh (i.e. stop on template abutting hopper end cap).
If gear teeth of template fail to mesh at first attempt, lower front and rear hopper
guards and press start. To rotate the drive gear press - then the green
button (14).
Retry full engagement of template after re-hinging and popping up front and rear
hopper guards to gain access.
6 Tighten nuts on underside of hopper to secure template. Leakage of mix will
occur if the nuts are not securely tightened.
7 If offset-nozzle holder has been fitted to template check alignment of all nozzles
with each other and with axis of template (this may be critical for some products
and / or to avoid collision of nozzle holders whilst rotating). Adjust position by
twisting holder in its template tube.
8 Lower front and rear hopper guards.
Rotary template and
standard accessories
Alignment of offset holders in rotary template