Monmouth Scientific Cleanroom Kit 4M, Installation Manual

Page: 47 / 72

Issue 03 – June 2018 47
Installing Clean Air Modules (CAM)
Clean Air Modules are fitted into position in the correct spot on the ceiling. The modules will need
the flange rails bolted on the sides prior to installation as these will stop the CAM falling through the
hole in the ceiling!
The CAM units are HEAVY! We would recommend
using suitable lifting equipment at all times when
handling the CAM modules.
The fitting of any CAM unit is a two person (minimum)
process. Suitable access equipment should be used
and your own risk assessment should be undertaken
when installing CAM modules. All personnel must be
suitably trained in the use of any access or lifting
equipment. It is the customer’s responsibility to ensure
the safety of all colleagues and personnel carrying out
this task. Monmouth Scientific Limited do not accept
responsibility for any injury or damage howsoever
caused.
YOU MUST NEVER LIFT, PUSH OR SUPPORT THE CAM UNIT ON THE FACE OF THE FILTER. THIS IS
EXTREMELY DELICATE AND WILL DAMAGE THE FILTER AND ULTIMATELY THE EFFECTIVENESS OF
YOUR CLEANROOM.