Monmouth Scientific Cleanroom Kit 4M, Installation Manual

Page: 22 / 72

Issue 03 – June 2018 22
5.
Carefully check the size of the required sheet
and its orientation. Peel away the protective
sheet from BOTH sides of the sheet – if you wish
to keep the sheet protected during assembly of
the room, then just peel away from the edges.
6.
OPTIONAL: Should you wish the structure to be
more permanent, then in each channel you can
add a SMALL bead of clear silicone sealant (not
supplied) before inserting the panel. This will
stop any movement in the panel once fitted
however it will be more difficult to take apart
should you wish to relocate the room.
If you choose to do this and silicone squirts out
from the sides of the panel and becomes visible,
then you are using too much – ONLY A SMALL
AMOUNT IS REQUIRED.
7.
Position the sheet into the slots as necessary.
The sheet will slide in the slots however when
sliding down between two uprights, it may be
easier to loosen the grub screw on the joints.
8.
Ensure the sheet is located in all slots and DON’T
FORGET to re-tighten the grub screws if you
loosened them.