83D0511
ILDV20/ILDV30 Fireplace Insert
1
LOG PLAceMeNt
Before you begin
- This unit is supplied with six (6) ceramic fiber logs. Do not handle these logs with
your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling
the logs, wash your hands gently with soap and water to remove any traces of fibers.
W
ARN
iNG
the positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly posi-
tioned in the appliance. Never add additional logs or embellishments such as pine
cones or vermiculite to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal in-
jury.
iNStALLiNG LOGS AND ROcK WOOL (eMBeR MAteRiAL) iN FiReBOx
1. Break up rock wool (ember material) into dime-sized pieces. Place evenly as shown. Do not exceed
1" layer covering all round burner ports.
Refer to Figures 16a and 16b.
. Do not cover rectangular slots located at rear of burner.
LG536
ILDV
ember material
9/08
Ember Material
LG536
Figure 16b
Place Ember Material
FP1968
ember material area
9/08
Ember Material Area
FP1968
Figure 16a
Ember Material Area
W
ARN
iNG
Do not use the entire
bag of rock wool to
cover burner area.
