To Set Speed
- Push and release ON switch on steering wheel and drive at desired
speed above 30 mph. Hold desired speed with your foot while you press and release SET
switch on steering wheel. One second after release, remove your foot from accelerator
pedal. You can increase your speed at any time with accelerator pedal. When you release
pedal you will return to set speed.
To Accelerate
- Push and hold in on SET switch on steering wheel and your
motorhome will accelerate. When you release switch, your motorhome set speed will be
automatically set to the accelerated speed.
To Coast
- Press and hold in COAST switch on steering wheel and allow
motorhome to coast. When you release switch your motorhome set speed will be auto-
matically set to the coast speed.
To Disengage
- Depress brake pedal and you are in control of motorhome’s speed.
You can also disengage speed control by pressing and releasing OFF switch on steering
wheel.
To Resume
- When you disengage system with brake you do not erase set speed
from memory even if you come to a complete stop. To return to your chosen speed drive
to a speed above 30 mph then push RESUME switch on steering wheel. Speed control
will take you back to your original set speed. If rate of acceleration is faster or slower
than you like, use accelerator to obtain a speed close to set speed then push RESUME
switch. Speed control will automatically be turned off when ignition switch is turned off.
Wiper/Washer Operation
Push in and hold end of arm to dispense washer fluid and release to stop fluid.
Wipers will turn on and off automatically.
When rotating end of arm from OFF to DELAY, you will turn wipers on and a delay
between wipes (ranging from 45 seconds to 2 seconds) will occur. Delay time changes as
arm end is rotated. A continuous low or high speed can be obtained by rotating arm end
to appropriate position. To turn wipers off, rotate arm end to OFF position.
Headlight Beam Change & Turn Signals
Move arm upward for a right hand turn signal, and downward for a left hand turn
signal. Push arm away from steering wheel to switch from low to high beam, or pull
towards steering wheel into detente position for high to low beam. Pull arm all the way
up to turn headlights on for flashing.
Monarch
9-4
Chassis Information
Chassis Information
M
ONACO
2000
Summary of Contents for Monarch 2000
