Monaco DIPLOMAT 2004, Owner'S Manual

Page: 378 / 446

DIPLOMAT 2004
10 • 378
CHASSIS INFORMATION
Reading Configuration Codes:
1. Turn the ignition key to ON.
2. Apply and release brakes once before proceeding.
3. Press and hold the diagnostic button for two seconds and release,
immediately press the diagnostic button a second time for two
seconds and release.
4. The four-digit configuration code is retrieved and displayed. It
should read 1-2 pause 4-5.
Retrieving Fault Codes:
1. Turn the ignition key to ON.
2. Apply and release brakes once before proceeding.
3. Press and hold the diagnostic button for two seconds and release.
4. Two-number blink codes are retrieved and displayed. A two-digit
display of 1-1 indicates no faults; the ABS system is functioning
properly.
Clearing Fault Codes and/or System Configuration:
1. With the ignition OFF, press and hold the diagnostic button.
2. Turn the ignition key to ON while pressing the diagnostic button.
3. Wait two seconds and release the diagnostic button.
4. Press and release the brake pedal.
5. The ECU is reconfigured to match connected components and
fault codes are cleared.
6. Repeat the "Retrieving Fault Codes" procedure to verify that
fault codes are cleared.
Disabling ATC for Dynomometer Testing:
1. Turn the ignition key to ON.
2. Press and hold the diagnostic button for at least 3 seconds and
release.
3. The ATC light turns ON and the fault lamp blinks 17-8,
indicating the ATC system is disabled. All subsequent flashes are
active ABS fault codes.
4. The ATC system will be enabled when the ignition is switched
off then back to on.