aPPlIances —
9
2 0 0 8 l a Pa l m a X l
WaSher/Dryer
NOTE:
Washer/Dryer is
not available on all
units.
The automatic
washer/dryer is front
loading with an extra
large door opening for easier access. Several
wash and dry programs are available along with
variable water temperature settings.
The washer/dryer operates on 120 Volt
AC from shore power or the generator.
The washer/dryer uses about 12 to 20
gallons of water per wash cycle.
CAUTION:
It is highly recommended that the
motorhome is hooked to shore services
when using the washing machine due
to limited fresh water supply and
limited holding tank capacity. On
certain model floor plans and options,
the washer may drain into the black
tank.
INFORMATION:
Refer to the washer/dryer OEM
manual for detailed operating
instructions.
WARNING:
Open a window or vent while
operating the dryer. The washer/dryer
can create negative air pressure inside
the motorhome that can accumulate
Carbon Monoxide or LP-Gas while
operating fuel-burning appliances.
CAUTION:
DO NOT use the washer/dryer while
traveling. Suspension movement,
combined with the weight of the drum
while in the wash cycle, can damage
the internal components of the washer/
dryer.
Test Procedure:
Before using the washer, after winter storage
or a long period of non-use, conduct a simple
test procedure to verify that all the hardware and
electronic components are functioning. Wipe the
inside and outside with a damp cloth to remove
accumulated dust.
NOTE:
Perform this test before putting the
washer/dryer in use or after the winter
months. This will clear the water lines
and drum of winterization antifreeze.
Operation
Test Procedure Requirements:
Make sure water supply lines are secure
and fresh water valves are open.
Hook to city water or turn on the water
pump.
Hook to shore power or start the
generator.
To Conduct the Test Procedure:
1. Set the selector knob to Reset.
2. Set the Dry Timer knob to 30 minutes.
Push the On/Off button to
ON
. Wait 5
seconds. The Auto Dry light should be
on and the Status light flashes fast then
slow.
3. Set the selector knob to a wash cycle.
Set Wash Temp knob to Warm. Water
should be flowing into washer and
drum should rotate both directions.
4. Set the selector knob to Reset. Wait 5
seconds.
5. Set the selector knob to Spin. Water
should drain and drum rotation should
speed up.
6. Set the selector knob to Reset. Wait 5
seconds.
7. Set the selector knob to Dry. Dryer fan
should begin and drum should rotate
both directions.
8. Set the selector knob to Reset. Wait 5
seconds.
9. Set the Dry Time knob to zero. The
Auto Dry light should go off.
10. The door will unlock in 2 minutes or
less. The Status light flashes fast then
slow. The door should now open.
11. Push the On/Off button to Out (
OFF
)
position. The Status light should be
off.
12. If applicable, close the holding tank
drain valve.
CAUTION:
DO NOT use heat to dry articles
containing foam rubber or similar
textured, rubber-like materials.
031017g
031017e
Summary of Contents for 2008 LaPalma XL
