equIPment —
102
2 0 0 8 l a Pa l m a X l
Adjusting the Screen Door:
Loosen the fasteners on the hinge side of
the screen door; two on the top and two
on the bottom.
The steel hinge has slots to allow
movement.
Four Phillips type screws are on the top
hinge and on the bottom hinge to adjust
for proper fit. The hinge should fit tightly
to the trim of the door when the screen
door is latched to the door and the door
is open.
Removable Screen:
The top half of the screen door is
removable to allow a clear view through
the entry door glass while in operation.
To remove the top half of the screen door
for travel, rotate clips and remove the
screen.
To store the screen for travel, use the
clips provided on the bottom half of the
screen door.
SlIDe-out operatIon
Slide room operation uses safety features to
prevent mechanical damage or physical harm.
Slide room(s) will not operate until all safety
requirements are met. To prevent damage to
cabinet doors or the slide room, secure all
cabinet doors in the closed position prior to
room activation. Some interior doors may
require being fully open or fully closed for the
slide room to operate. Ensure the pilots seat is
moved forward to prevent damage when the
slide room is operated.
Safety Requirements:
Ensure the ignition key is in the
OFF
position when extending the slide room.
The park brake must be applied.
CAUTION:
DO NOT leave the slide room extended
during severe weather. Conditions such
as high winds or heavy rain may cause
damage. Rain water can pool on the
slide room awning, adding weight and
causing the awning to sag. Retract the
room in small increments to allow water
run off.
CAUTION:
Never move the motorhome with any
slide room extended. Perform the slide
room operation with the air suspension
system full.
CAUTION:
Extensive damage could occur to
the slide-out room and awning when
extending the slide-out room in snow,
sleet, ice or freezing rain conditions. In
such conditions, if the slide-out room is
extended, clear the awning and ensure
free movement prior to operating the
slide-out room.
Operation Requirements:
House battery disconnect switch must be
on.
House batteries must be fully charged.
Guidelines to ensure long life of slide
system:
Inspect
roof of the slide for debris such
as pine needles, dirt, leaves, sticks, etc.
Debris left on the top may cause damage
to the seals during retraction. If debris is
present, wash with soap and water, then
rinse.
When the room is out, visually
inspect
the wipe seal for dirt or other foreign
material and for tears.
If the slide room leaks, fully retract the
room. If necessary, tape exterior opening
closed with duct tape until repairs to the
motorhome can be completed.
CAUTION:
Firmly latch all cabinet doors adjacent
to the slide before extending or
retracting the rooms. Damage to doors
or the fascia may occur.
NOTE:
Dirt and grit trapped under the slide
room can scratch and damage the floor.
Clean the floor before retracting the
slide room. Never move the motorhome
with the slide room extended.
NOTE:
DO NOT use petroleum based products
on the slide seal. Petroleum based
products can damage the paint and will
cause premature aging of the rubber
seal.
060306b
Monitor Panel located in hallway area.
Summary of Contents for 2008 LaPalma XL
