General Information
Battery pack and AC
Battery pack and AC
power requirements
power requirements
The CT100 may be operated using either the supplied AC adapter, the internal NiMH batteries (for
a minimum 6 hours operating time, typical use), or optional hot-swappable external 14.4 VDC
battery packs (for unlimited portable use). The internal NiMH battery charges under AC during
normal operation.
The external AC power adapter is intended to be used with either a 120 VAC or 240 VAC RMS
power source. Use of a standard 3-prong AC socket with intact ground connection is essential for
safe operation of the CT100 with the included AC power adapter. Review the
Safety Summary
section before operating the CT100.
Options and accessories
Options and accessories
Options and accessories available for the CT100 are described on page 53.
Unpacking
Unpacking
and initial
and initial
inspection
inspection
Before opening the shipping package containing the CT100, first inspect it for signs of damage. If
there is evidence of damage to the shipping package, notify both the shipping carrier and MOHR.
The shipping container should contain the CT100 and standard accessories, including an
Operator's Manual
, front panel cover, external AC adapter and power cord, soft transit case, and
calibration fixture(s). If the shipping container is intact but there are missing items or if the CT100
is damaged, defective, or does not meet operational requirements, contact a MOHR-authorized
sales representative.
Repacking
Repacking
for shipment
for shipment
When the CT100 needs to be shipped to a MOHR-authorized service center for repair, calibration,
or other service, affix a label to the outside of the shipping container indicating the name, address,
phone, and e-mail of the owner, the name of the MOHR service representative who was contacted
regarding the shipment, the serial number of the instrument, and a description of the problem with
the instrument and/or the desired service or maintenance.
Optimally, the original shipping carton and packing material should be used to repack the CT100
for shipment. Otherwise, the following steps should be taken:
1) Obtain a heavy-duty corrugated cardboard box at least 6 in. (15 cm) larger in each dimension
than the equipment to be shipped to allow for protective cushioning material. The shipping
carton should have at least 200 lb. (90.7 kg) test strength.
2) Make sure the CT100 is turned off by setting the rear panel power switch to the OFF position.
3) Install the front panel cover.
2
Mohr CT100 / CT100HF Operator's Manual
